హెచ్ఐసి ఆంధ్ర కన్వేయర్ రొలర్ల యొక్క అయిడిలర్ మార్గదర్శి

How to Install Carrying Idler

All carrier idlers should initially be squared with the path of the belt and only the minimum shifting of idlers used as a training means. If the belt is over-corrected by shifting idlers, it should be restored by moving back the same idlers, not by shifting additional idlers in the other direction.

Obviously such idler shifting is effective for only one direction of belt travel. If the belt is reversed, a shifted idler, corrective in one direction, will misdirect in the other. Hence reversing belts should have all idlers squared up and left that way. Any correction required can be provided with self-aligning idlers designed for reversing operation. Not all self-aligners are of this type, as some work in one direction only.

Tilting the troughing idler forward (not over 2°) in the direction of belt travel produces a self-aligning effect. The idlers may be tilted in this manner by shimming the rear leg of the idler stand. Here again this method is not satisfactory where belts may be reversing.

Return Idlers Installation Method

Return idlers, being flat, provide no self-aligning influence as in the case of tilted troughing idlers. However, by shifting their axis (knocking) with respect to the path of the belt, the return roll can be used to provide a constant corrective effect in one direction. As in the case of troughing rolls, the end of the roll toward which the belt is shifting should be moved longitudinally in the direction of return belt travel to provide correction.

Self-aligning return rolls should also be used. These are pivoted about a central pin. Pivoting of the roll about this pin results from an off-center belt and the idler roll axis becomes shifted with respect to the path of the belt in a self-correcting action. (Figure 6) Some return idlers are made with two rolls forming a 10° to 20° V-trough, which is effective in helping to train the return run.

A further aid to centering the belt as it approaches the tail pulley may be had by slightly advancing and raising the alternate ends of the return rolls nearest the tail pulley.

When to Install Side Guide Rollers

Guide roller be used to afford the protection to the belt as an emergency measure, provided that they do not touch the belt edge when it is running normally. If they bear on the belt continually, even though free to roll, they tend to wear off the belt edge and eventually cause ply separation along the edge. Side guide rollers should not be located so as to bear against the belt edge once the belt is actually on the pulley. At this point no edge pressure can move the belt laterally.

హెచ్ఐసి అంతర్జాతీయ కం. యొక్క తయారీ యూనివర్సల్ బ్రాండ్ నాణ్యతగల స్టీలు మరియు రబ్బరు కలయిక అయిడిలర్ రోలర్లు IS8598 ను ఆధిగమిస్తుంది దాని దివ్యమైన హౌసింగ్ మరియు సీలింగ్ సిస్టమ్ స్థితి యొక్క లాభము దీర్ఘకాలిక మన్నికకు నమ్మకాన్నిస్తుంది